Advertisement
Using the Pro-Ject Stereo Box
1
2
Input
Select
Power
Stand-By
The switch marked Power (press and hold to switch into standby mode) on the front panel and ON/OFF
button on the remote control turn the unit on or back into standby. The blue LED on the front panel shows that
the unit is powered on.
Input selector
After the unit is powered on, pressing the Power button selects the In 1 and In 2 inputs in turn. Select the
inputs using the remote control buttons marked CH- or CH+. If Input 1 is selected, the LED over the Input
Select button lights up green. If Input 2 is selected, it lights up red.
If the optional input expander Pro-Ject Switch Box is connected, Input Select will also select the additional
inputs provided by the Switch Box.
Volume
Adjust the volume to the desired level using the large knob marked Volume on the front panel or by using
the buttons on the remote control marked VOL- or VOL+.
Remote control Pro-Ject Stereo Box
ON/OFF
CH+
VOL+
VOL-
CH-
Changing batteries
Proceed as follows:
•
Slide open the battery case cover
•
Replace the battery. Make sure the battery is the right way round
•
Refit the battery case cover
Battery type: 1 x CR 2032 / 3V
Do not dispose the batteries as ordinary domestic refuse. Please dispose your exhausted batteries at
the appropriate collection sites - usually located at supermarkets and drugstores.
Volume
Stereo Box
ON/OFF switches the unit into and back out of the standby mode
VOL- and VOL+ adjusts the sound volume
CH- and CH+ selects the inputs
© Audio Trade GmbH · Pro-Ject Pre Box · Revision 15.4.09/1.6.09
3
Advertisement
