Advertisement
Technical specifications Pro-Ject Stereo Box
Power output:
Frequency response:
Channel separation:
Noise floor:
THD:
Gain:
Line-level inputs:
Input impedance:
Trigger Switch:
Speaker connectors:
Outboard power supply:
Power consumption:
Replacement battery remote control:
Dimensions (W x H x D):
Weight:
Service
Should you encounter a problem which you are not able to alleviate or identify, please contact your dealer for
further advice. Only when the problem cannot be resolved there should the unit be sent to the responsible
distributor in your country.
Warranty
The manufacturer accepts no responsibility for damage caused by not adhering to these instructions
for use. Modification or change to any part of the product by unauthorized persons release the
manufacturer from any liability over and above the lawful rights of the customer.
PRO-JECT is a Registered Trademark of H. Lichtenegger.
This guide was produced by: Audio Trade GmbH
Copyright © 2008. All rights reserved.
4
© Audio Trade GmbH · Pro-Ject Stereo Box · Revision 15.4.09/1.6.09
2 x 20W/30W at 8ohms/4ohms (both channels driven)
20Hz - 20kHz (+ - 0,2 dB)
> 40dB at 20kHz
> -100dB (A weighted)
< 0,05% at 10W
22dB
2 pairs RCA/Phono sockets
20kohms
2-pole 2,5mm co-axial jack
4mm ∅ banana plugs, spades connectors or naked wire
20V/3A DC (peak 7A DC), suitable for your country's mains supply
20V/3A DC
1 x CR 2032 / 3V
103 x 38 x 141mm
720g without power supply
The information was correct at the time of going to
press. The manufacturer reserves the right to make
changes to the technical specification without prior
notice as deemed necessary to uphold the ongoing
process of technical development.
Advertisement
