Table of Contents
Advertisement
www.mgeups.com
1.1.4 Connection
Before installing the MGE Network Solution, the UPS must be set up as indicated in the steps below.
Shut down the computers to be protected by the UPS.
Connect the UPS to a wall outlet. (For UPSs above 3kVA, please refer to the UPS installation manual)
Connect the power cord of each computer to an outlet on the UPS. (For UPSs above 3kVA, please refer to
the UPS installation manual)
1.1.4.1 How to connect UPS / agent / network :
Insert the optional card in the UPS and connect the UPS to the computer network.
Start the MGE UPS, then the computers.
1.1.4.2 Setting up the protection
Set up the Network Management Card (see user manual).
T H E
U N I N T E R R U P T I B L E
Network Management Card
P O W E R
– User Manual
34003676EN/BB
Network
Management Cards
User Manual
P R O V I D E R
Page
7/76
Advertisement
Table of Contents
