Table of Contents
Advertisement
www.mgeups.com
COMMANDS -
1. Modify - Modify an entry of table
2. Reset - Reset an entry to default from table
0. Return to previous menu
Please Enter Your Choice =>
This menu enables configuration of access to the four supervision stations (identified by the IP address) with
read/write community names different to those already defined in the card "1" menu.
First enter the figure corresponding to the command to be carried out, then the number of the target input.
The example below shows how to configure the read/write rights for a station (172.17.1.1) with a community
name MyCom:
Please Enter Your Choice => 1
Entry Number : 1
Enter IP address : [0.0.0.0] 172.172.1.1
Enter Community String : [public] MyCom
Select Access Type -
[NotAccess]
1. Read
2. Read/Write
3. NotAccess
Please Enter Your Choice => 2
+============================================================================+
| IP Address
Community String
+============================================================================+
[1] 172.172.1.1
MyCom
5.1.4 Choice 4: Restore default configuration
Use this function to restore the card's factory configuration. Reboot the card so that the network parameter
changes are taken into account.
5.1.5 Choice 5: Reset the card
Use this function to reboot the card
T H E
U N I N T E R R U P T I B L E
Network Management Card
Access
Read/Write
P O W E R
– User Manual
34003676EN/BB
Network
Management Cards
User Manual
|
P R O V I D E R
Page
66/76
Advertisement
Table of Contents
