Operating Adjustments; Aligning The Degree Scale Pointer; Power On/Off Switch; Adjusting The Blower - Dremel ScrollStation 1830 Owner's Manual

Operating Adjustments

Aligning the
Degree Scale Pointer
The table is factory set to 0º. If further adjustments are nec-
essary, please follow the instructions below:
1. Loosen the table lock knob and move the table until it is
90° to the blade.
2. Remove the blade, remove the drop foot assembly, then
reinstall the blade (see REMOVING AND INSTALLING
BLADES, page 11 or 12). Place a small square on the
table next to the blade as shown in (Figure 11) to check
if the table is 90º to the blade. If no adjustment is
required, re-install the drop foot assembly.
If adjustment is necessary. Loosen, but don't remove the
two screws holding the pointer. With the steel ball cen-
tered in the 0º detent, slide the pointer left or right until
the blade is parallel to the square.
3. Tighten the table lock knob, both screws, and reinstall
the drop foot. Remember, the degree scale is a conve-
nient guide but should not be relied upon for precision.
Make practice cuts in scrap wood to determine if your
angle setting is correct.

Power ON/OFF Switch

Turn the power on or off using the Power ON (I) / OFF (O) switch
(Figure 12).
Your saw features an overload switch that protects the motor
from overheating and damage. If the switch is tripped, the motor
will automatically stop. When this occurs, turn the ON/OFF
switch to the OFF (O) position. The tool will automatically reset.
Turn the power switch to the ON (I) position.

Adjusting the Blower

Position the blower as needed to blow-off sawdust from the
workpiece (Figure 12).

Variable Speed Control

Turn the control to vary the speed of the saw (Figure 12).
Drop Foot
Wing Knob
Blade
(Angle
Adjustment)
Degree Scale
Pointer
Pointer
Adjustment Screw
Figure 11. Aligning the Degree Scale Pointer
Variable Speed Control
Figure 12. Adjusting the Blower
14
Drop Foot Wing Knob
(Height Adjustment)
Square
Steel Ball
Power ON/OFF Switch
Blower