Assembly; Mounting The Scrollstation To A Bench; Mounting The Scrollstation To Plywood - Dremel ScrollStation 1830 Owner's Manual

Mounting the ScrollStation
to a Bench
The ScrollStation should be fastened securely to a firm sup-
porting surface such as a stand or workbench, using the three
mounting holes.
NOTE: When mounting this saw to a workbench, a solid
bench is preferable to a plywood bench where noise and
vibration will be more noticeable.
We recommend to reduce noise and vibration, that a soft
foam pad be placed between your ScrollStation and work-
bench (not included).
Quantity Description
1 Soft foam pad, such as carpet padding,
24"x12"x1/2"
When mounting the ScrollStation to a workbench, holes
should be drilled through the foam pad or carpet and mount-
ing surface of the workbench using the dimensions illustrated
in Figure 3.
Each of the three mounting holes should be bolted securely
using no less than 1/4" hex bolts, flat washers, lockwashers,
and nuts (not included). We recommend:
Quantity Description
4 Hex Head Bolts,
1/4"-20 x 1/4"-20 x Length Required
4 Flat Washers, 9/32" I.D.
4 Lockwasher, 9/32" I.D.
8 Hex Nuts, 1/4"-20
(Hardware not included)
Refer to Figures 3 and 4.
1. Locate and mark where the ScrollStation is to be mounted.
2. Drill the three (3) 5/16" holes through the workbench.
3. Place the ScrollStation on the workbench aligning holes
in the base with the holes drilled in the workbench. Insert
all three (3) bolts and secure using washers, lockwash-
ers and nuts.
NOTE: Do NOT overtighten mounting bolts. If using recom-
mended foam pad, leave some cushion in the foam pad for
absorbing noise and vibration.
Mounting the ScrollStation
to Plywood
An alternative method of securing your ScrollStation is to fas-
ten the ScrollStation base to a mounting board 18" x 24". Any
good grade of plywood with a 3/4" minimum thickness is rec-
ommended. Follow the instructions for MOUNTING THE
SCROLLSTATION TO A BENCH, substituting the 18" x 24"
board for the workbench and using 1/4"-20 flat head screws
for the hex head bolts (Figure 4). Screws must be mounted
from underneath the plywood with washers and nuts on top.

Assembly

NOTE: For proper stability, holes must be countersunk so
screw heads are flush with the bottom surface of the sup-
porting board.
Figure 4. Table Mounting Hardware (not included)
15"
10
11-7/8"
19-13/16""
Figure 3. Bench Mounting Template
24"
11-7/8"
19-13/16"
Figure 5. Plywood Mounting Template
7-7/8"
7-7/8"