Rear-Facing Installation With Seat Belt - Evenflo Symphony 65 Owner's Manual

Rear-facing Installation with Seat Belt

IMPORTANT:
• If you are using lower anchor connectors to secure the
child restraint, DO NOT use the vehicle seat belt.
• Before installing this child restraint rear-facing with the
vehicle seat belt, you MUST move the lower anchor con-
nector assembly to the forward-facing belt path so that
it does not interfere with the vehicle seat belt. Refer to
pages 32 to 34 for instructions on moving the SureLatch
connectors or Quick Connectors to the forward-facing belt
path.
• Make sure the SureLatch connectors or Quick Connectors
are attached to the storage D-rings on the seat pad.
• DO NOT use the tether strap when the child restraint is
in the rear-facing position.
Rear-facing Belt Path
Thread the vehicle seat belt buckle through the
rear-facing belt path, as shown on the next page.
26
1. Place the
child restraint
in position.
Adjust the child
restraint to the
most reclined
position (Recline
Position #1, p. 53),
then place it on
vehicle seat in the
rear-facing posi-
tion, as shown.
2. Route seat
belt through
rear-facing
belt path.
Unhook the front
of the seat pad
and move it out of
the way, as shown.
Rear-facing Installation with Seat Belt
Lap Belt Only
IMPORTANT: Make sure
the buckle/crotch strap
is positioned in front
of the vehicle seat belt.
Lap and Shoulder
Belt Combination
3. Buckle seat belt,
then remove all
slack from the seat
belt.
Using your full weight,
push the child restraint
firmly onto the vehicle
seat while tightening
the vehicle seat belt to
remove excess slack.
27