Okina L08FF-04 Setup Manual page 7

Playback Controls:
Button Description
The button is for rewinding the recorded video while playing back. Press the button
LEFT
repeatedly to increase the speed of reverse playback by 1×, 2×, 4×, 8×, 16×, or 32×.
The button is used to play the recorded video fast forward. Press the button
RIGHT
repeatedly to increase the speed of forward playback by 1×, 2×, 4×, 8×, 16×, or 32×.
Press FREEZE to pause the playback video. When the recorded video is paused,
FREEZE press LEFT / RIGHT to resume playback video single step reverse / forward
respectively. Press FREEZE again to continue playing back video.
Play/Stop Press to start the playback or to stop playing back video and return to live mode.
Connect the DVR via the Remote Software
Setup Requirements:
•
Make sure the PC is connected to the Internet.
•
Obtain IP address of the ECO H.264 DVR. To check the DVR's IP address, press MENU on the
front panel and select <System Setup>
check the IP.
Changing Internet Setting:
•
Start the IE; select <Tools> from the main menu of the browser, then <Internet Options> and
then click the <Security> tab.
•
Select <Trusted sites> and click <Sites> to specify its security setting.
•
Uncheck "Require server verification (https:) for all sites in this zone". Type the IP address of the
unit in field and click <Add> to add this website to the zone.
•
In the Security Level area, click <Custom Level>. Under <ActiveX controls and plug-ins>,
set all items to <Enable> or <Prompt>.
•
Click <OK> to accept the settings and close the <Security Settings> screen.
Using the Remote Software:
•
Start the IE and enter the IP address of the ECO H.264 DVR in the address bar.
•
The ActiveX controls and plug-ins dialog will show twice for confirmation; click <YES> to accept
ActiveX plug-ins. The DVRRemote plug-ins will be downloaded and installed on the PC
automatically when the connection is successfully made.
NOTE: Do not enter any leading "0" characters in the address, for example,
"192.068.080.006" should be entered "192.68.80.6".
NOTE: If the default trigger port 80 is changed into another one, port 81 for example,
then the IP address should be entered as "192.68.80.6:81".
<Network Setup> <LAN Setup> <IP> to
7