Advertisement
Authorized Monte Carlo Dealer www.NovaLightingStore.com 800-860-1207
7
Insert downrod into yoke on top of the Fan
Body. Align the hole in the Downrod with the
hole in the Yoke. Insert the Pin through the
Yoke and Downrod until the point appears on
the other side.
10
Safety cable installation
Safety Cable
Lag Screw
safety
cable
washer
lock
3" lag
washer
screw
For Canadian installation and for USA fan and
light kit combinations over 35 lbs, in both flush
and downrod mode the safety cable must be
installed into the house structure beams using
the 3" lag screws,washers, and lock washers.
provided. Make sure that when the safety cable
is fully extended the leadwires are longer than
the cable and no stress is placed on the lead-
wires.
13
House
Black
White
Ground
Connect black and blue wire from fan to Black or (Hot)
wire from house. Connect White wire from Fan to
White (Neutral) wire from house. Connect Ground
leads from mounting bracket and downrod to Ground
lead from house. Refer to Safety Tips section of
manual.
16
Next lift the cover ring and install knurled
nuts as shown. Tighten the knurled nuts
securely. The canopy should adjust for
any irregularity in the ceiling or Outlet
box.
Monte Carlo Fans & Fixtures Available at www.NovaLightingStore.com 800-860-1207
8
Install the keeper to pin.
11
Make sure the studs protruding from the
bottom of the Mounting bracket are
installed with threads all the way through
the bracket.
14
Fan
Blue
Black
White
Green
Make wire connections to power source using wire nuts
provided. Make sure that no filiments are outside of
the wirenut. After making the wire connections, the
wires should be spread apart with the grounded con-
ductor and the equipment-grounding conductor on one
side of the outlet box and ungrounded conductor on
the other side of the outlet box.
17
F F l l u u s s h h M M o o u u n n t t I I n n s s t t a a l l l l a a t t i i o o n n
Pass leadwires and safety cable
through the canopy.
9
Tighten the 2 set screws on the Yoke
once the downrod is in place.
12
Hang assembled fan from the mounting bracket
installed to ceiling in previous step. Make sure the
fan is hanging straight. Rotate fan until the tab on
the Mounting bracket engages the slot on the
Downrod Ball. This must be done to prevent the fan
body from rotating when the blades are in motion.
15
Lift Conopy allowing the 2 studs
to protrude through the canopy.
18
Remove side covers from canopy
exposing 4 holes. 2 closed holes
and 2 open "L" shape holes.
Cover Ring
Advertisement
