Table of Contents
Advertisement
ATX Power ON Switch: Pins 7 and 17
This 2-pin connector is an "ATX Power Supply On/Off
Switch" on the motherboard that connects to the power
switch on the case. When pressed, the power switch will
force the motherboard to power on. When pressed again, it
will force the motherboard to power off.
Turbo LED Connector: Pins 8 and 18
There is no turbo/deturbo function on the motherboard. The
Turbo LED on the control panel will always be On when
attached to this connector.
Reset Switch: Pins 9 and 19
The reset switch allows the user to reset the system without
turning the main power switch off and then on again.
Orientation is not required when making a connection to this
header.
Hard Disk Drive LED Connector: Pins 10 and 20
This connector connects to the hard drive activity LED on
control panel. This LED will flash when the HDD is being
accessed.
TI6VG4 User's Manual
Chapter 5 Installation
Pin #
Signal Name
8
5V
18
Ground
Pin #
Signal Name
10
HDD LED
20
5V
27
Advertisement
Table of Contents
