Advertisement
Hunter Original and
Non-removable Switch,
No Center Hole
Screw
Switch
Step 1
Housing
Plate
43525-01 r091107
Installing the Light Kit on Fans With Non-Removable Switch Housing
and No Center Hole
1. Uninstall the two screws from the switch housing plate.
2. Remove the wire connectors from the two wires in the switch housing
labeled "Connect Light Here" or "For Light Use." One wire is white and the other wire
is black/white striped.
Connect the black/white striped wire from the switch housing to the black wire from
the light kit. Connect the white wire from the switch housing to the white wire from
the light kit. Secure all wire connections using wire connectors.
To connect the wires, hold the bare metal leads together and place a wire connector
over them, then twist the wire connector clockwise until tight.
CAUTION: Be sure no bare metal wires or wire strands are visible after making
the connections.
3. Finish attaching the light kit to the switch housing. Use the two screws removed
from the switch housing and the lock washers on the red tag. Screw the light kit into
the two tabs in the switch housing. Securely tighten the two screws.
WARNING: Improper installation could cause the light fixture to fall, or result
in electrical shock or personal injury.
4. Go to the instructions for Installing Bulbs, Chains, Shades.
Wires
and Wire
Connectors
Step 2
Screw and
Washer
Light Kit
Mounting
Step 3
Plate
I
O
3
Advertisement
