Roland JEWELA JWX-10 User Manual page 54

5-2 What to Do If
[Operation or view in progress. Please wait until
operation stops, or cancel the view.]
An attempt was made to perform an operation or
make settings using the operation panel screen while
the machine was either in operation or paused.
The operation panel screen cannot be used to start a new
operation or make new settings while a cutting operating is
in progress or when the machine is paused. Either wait un-
til the operation ends or cancel the paused state, then carry
out the operation or make the settings.
[No sensor is connected.]
The sensor was not connected to the machine dur-
ing origin-detection operation.
Make sure the sensor is installed on the machine and the
connector is connected.
[Emergency stop -- excess current to spindle. Please
switch off machine power.]
An emergency stop occurred because the spindle
experienced excessive load.
Make the cutting parameters more relaxed, then carry out
cutting again.
If this message appears even after you have changed the
cutting parameters, then contact your authorized Roland
DG Corp. dealer or service center.
[Emergency stop -- voltage drop due to excessive
spindle load. Please switch off machine power.]
An emergency stop occurred because the voltage
drop.
Relax the cutting parameters, allow the machine cool down,
then carry out cutting again.
If this message appears even after you have changed the
cutting parameters and allowed the machine to cool, then
contact your authorized Roland DG Corp. dealer or ser-
vice center.
[Emergency stop -- spindle driver IC overheated.
Please switch off machine power.]
An emergency stop occurred because the spindle
became too hot.
Relax the cutting parameters, allow the machine cool down,
then carry out cutting again.
If this message appears even after you have changed the
cutting parameters and allowed the machine to cool, then
contact your authorized Roland DG Corp. dealer or ser-
vice center.
52 Chapter 5 Appendix
[Emergency stop -- spindle motor overheated.
Please switch off machine power.]
An emergency stop occurred because the spindle
motor become too hot.
Relax the cutting parameters, allow the machine cool down,
then carry out cutting again.
If this message appears even after you have changed the
cutting parameters and allowed the machine to cool, then
contact your authorized Roland DG Corp. dealer or ser-
vice center.
[X-axis [Y-axis/Z-axis/A-axis] limit-switch error.
Please switch off machine power.]
An error occurred during initialization of the ma-
chine.
This message may appear if head movement is obstructed
during initialization at startup. Switch the power off, then
back on.
[Settings cannot be saved or read. Please switch off
machine power.]
An error occurred either when setting the origin
location or during startup after making the settings.
The origin location could not be changed or set. Switch the
power off and back on, then redo the setting for the origin
location.
[Emergency stop -- cover opened during operation.
Please switch off machine power.]
The front cover was opened during cutting.
Operation cannot be continued. To ensure safety, opening
the front cover causes an emergency stop to occur. Switch
the power off and back on, then redo the cutting.
[Sensor error. Please switch off machine power.]
Origin detection using the sensor cannot be per-
formed.
Origin detection cannot be performed. Switch off the power
and detach the connector for the sensor. Then switch the
power back on and connect the connector for the sensor.