Roland JEWELA JWX-10 User Manual page 20

1-1 About This Machine
Side view
USB connector
Connect a USB cable (sold separately) to
this connector.
Power connector
Connect the supplied power cord to this
connector.
Operation buttons
TOOL-UP/TOOL-DOWN button
These buttons move the spindle up and
down. To stop cutting, pause the machine,
then press these two buttons at the same
time. This deletes all data sent to the ma-
chine.
18 Chapter 1 Introduction
Expansion connector
Main Power switch
This is the machine's main power
switch.
VIEW light
Lights up when the machine is
temporarily stopped. While the
lamp is on, the machine does not
receive processing data.
VIEW button
Press this button to temporarily stop the machine
and move the cutter to the top position. To restart
the machine, press the button once again.
Sensor connector
Connect the supplied sensor
cable to this connector.
Rotary axis unit connector
SCANNING light (optional)
This lights up while using the optional
scanning unit.
ENGRAVING light
This lights up when the Sub power but-
ton is pressed.
Power light
Lights up when the main
power switch is on.
Sub power button
Press this button to start the machine
when the main power switch is on.