Table of Contents
Advertisement
Memory extension
The workstation must be switched off when installing/removing the memory modules and
!
may not be in the Suspend mode.
So that the current data can be saved in the Save to Disk suspend mode, sufficient
memory space must be available on the hard disk (at least the size of the main memory +
2 Mbytes).
If the main memory is extended and you use the suspend mode Save to Disk on the
workstation, you must check the size of the first partition or adjust it accordingly if you are
using Windows NT (see the manual on Windows NT).
Install only memory expansions that satisfy the requirements and rules governing safety,
RFI and electromagnetic compatibility and relating to telecommunications terminal
equipment (see the chapter
Use only memory expansions which have been released for your workstation.
Never use force when installing or removing memory modules.
Make sure that foreign objects do not fall into the memory module compartment.
Memory modules
The main memory of your workstation can be upgraded to 64 -768 Mbyte with up to four 64 or 128
Mbyte memory modules or with up to three 256 Mbyte memory modules. The memory modules may
be mixed as required. The notebook will not start without memory modules, as no fixed main
memory is installed.
128/256 Mbyte 2-bank modules (100 MHz) may only be inserted in slots A, B and C.
A26391-K82-Z110-1-7619
"Important
notes").
A
B
C
D
47
Advertisement
Table of Contents
