Cargo Management System - GMC 2007 Yukon Denali Owner's Manual

4. Press the end caps in, this will allow the cover
to fit into the trim slot.
5. Lightly pull on the cover holder to make sure
it is secure.
On the extended wheelbase models there are
two cover positions. The slots furthest forward
allow the cover to be used if the third seat is
removed or folded down. The cover can be
installed and removed from either side.
Cargo Tie Downs
When not using the tie downs, flip them down out
of the way.
Your vehicle may be
equipped with cargo tie
downs in the rear
cargo area that allow
you to strap cargo
in and keep it from
moving inside the
vehicle.

Cargo Management System

Your vehicle may be equipped with a cargo
management system. It can be used for storing
and separating cargo and as a table. The
maximum load is 200 lbs. (91 kg) distributed. It is
located in the rear of the vehicle on upper or
lower horizontal guides. There are two vertical
curved guides that connect the upper and
lower horizontal guides together. The system has
three rollers on each side. The system has a
release lever located in the center of the grab
handle. This will engage and disengage a locator
pin. This is used in adjusting and positioning
the system.
The cargo management system can be positioned
on the upper or lower horizontal guides.
181