Using Your Shower - Mira Azora Installation & User Manual

Using your Shower

Read the section "Important.Safety.Information" first.
1.
Switch on electrical supply.
3.
Set to desired position.
5.
Allow 0 - 5 seconds for any temperature adjustments to reach the handset.
6.
P r e s s S TO P b u t t o n .
Shower will continue to run
for a few seconds before
stopping.
Note!.At the end of every shower make sure that the shower head points into the
catchment area. A small amount of water may be retained in the shower handset
after the shower has been turned off. This may drain over a few minutes.
2.
Press the 'Start/Stop' button.
4.
Check water temperature before
entering shower.
7.
Isolate power.
8
8.
Residual water may drain
over a few minutes.