Mira Azora Installation & User Manual page 8

•
Avoid layouts where the shower hose will be sharply kinked. This may reduce
the life of the hose.
•
A Hose Retaining Ring is supplied to prevent the handset from dropping below
the spill-over level of the bath or shower tray, which could lead to contamination
from back-siphoning. The supplied Hose Retaining Ring should meet the
majority of user requirements for shower installations with flexible outlet fittings.
However, there will be occasions when it will not provide a suitable solution.
In these instances an outlet double checkvalve, e.g. a Mira DCV-H,
be fitted. This will increase the required supply pressure typically by 10 kPa
(0. bar). Refer to section "Accessories".
•
Supply pipework
appliance.
•
To avoid damage to the case when soldered fittings are used, pre-solder the
pipework and fittings before connecting them to the inlet connector assembly.
Refrain from applying excessive force when making any connections. Always
provide mechanical support when making the plumbing connections.
•
The appliance is fitted with a brass inlet compression assembly for connecting
to a 5 mm supply pipe from the top, bottom or back. Double checkvalves, if
fitted in the inlet supply to the appliance, can cause a pressure build-up, which
could exceed the maximum static inlet pressure and damage the appliance.
Minimum
00 mm from
ceiling
Fixed to finished
wall surface
Isolating Valve
Avoid Sharp Kinks
must be flushed to clear debris before connecting to the
8
Convenient height
for all the family
Hose Retaining Ring
5 mm Min
Bath
must
Shower Tray