Specifications; Plumbing; Electrical; Standards And Approvals - Mira Azora Installation & User Manual

Specifications

1..Plumbing

•
Minimum maintained inlet pressure 70 kPa (0.7 bar).
00 kPa (.0 bar) recommended for satisfactory operation.
•
Maximum static inlet pressure 1000 kPa (10 bar).
•
Minimum static pressure 0 kPa (0. bar) to keep the inlet valve closed.

2..Electrical

•
The Mira Azora 9.8 kW requires a 45 Amp fuse.
•
The terminal block will accept cable up to 6 mm
3..Standards.and.Approvals
•
The Mira Azora complies with all relevant directives for CE marking.

Installation.Requirements

1..Plumbing
•
The appliance is designed to operate with a minimum maintained inlet pressure
of 0.7 bar up to a maximum static inlet pressure of 10 bar.
•
When installed in very hard water areas (above 00 ppm temporary hardness)
your installer may advise the installation of a water treatment device, to reduce
the effects of limescale formation. Your local water company will be able to
advise the hardness of water in your area.
•
It is recommended that a non-restrictive (free flowing) isolating valve is fitted in
the cold water supply pipe to allow the complete maintenance of the appliance.
Do not use a valve with a loose washer plate (jumper) as this can lead to a
build up of static pressures.
•
The appliance is suitable for installation within the shower area. It is fitted with
a pressure relief device and must be positioned over a water catchment area
with the controls at a convenient height for all users.
•
The appliance must be fitted on to a finished flat and even wall surface (this
wall surface should be tiled or waterproofed).
wall and tile up to the case. For safety requirements, an air gap must be left
behind the appliance.
.

Do.not
7
fit the appliance to the