Custom Firmware Installation; Adding A Switch To An Existing Fabric - HP StorageWorks SN6000 Installation And Reference Manual

5. Enter the password for your account name (FTP only).
331 Password required for johndoe.
Password:******
230 User johndoe logged in.
The firmware will now be downloaded from the remote host to the switch, installed, and activated.

Custom firmware installation

A custom firmware installation downloads the firmware image file from an FTP or TFTP server to the switch,
unpacks the image file, and resets the switch in separate steps. This allows you to choose the type of switch
reset and whether the activation will be disruptive (reset switch command) or nondisruptive
(hotreset command). The following example illustrates a custom firmware installation with a
nondisruptive activation.
1. Download the firmware image file from the server to the switch.
• If your server has an FTP server, you can enter the image fetch command:
SN6000 FC Switch (admin) #> image fetch account_name ip_address
filename
• If your server has a TFTP server, you can enter the image tftp command to download the
firmware image file.
SN6000 FC Switch (admin) #> image tftp ip_address filename
• If your server has neither an FTP nor a TFTP server, open an FTP session and enter FTP commands:
>ftp ip_address or switchname
user:images
password: images
ftp>bin
ftp>put filename
ftp>quit
2. Display the list of firmware image files on the switch to confirm that the file was loaded.
SN6000 FC Switch (admin) $>image list
3. Unpack the firmware image file to install the new firmware in flash memory.
SN6000 FC Switch (admin) $>image unpack filename
4. Wait for the unpack to complete.
image unpack command result: Passed
5. A message will prompt you to reset the switch to activate the firmware. Use the hotreset command to
attempt a non-disruptive activation.
SN6000 FC Switch (admin) $>hotreset

Adding a switch to an existing fabric

If there are no special conditions to be configured for the new switch, plug in the switch. The switch
becomes functional with the default fabric configuration. The default fabric configuration settings are as
follows:
• Fabric zoning is sent to the switch from the fabric.
• All ports will be GL_Ports.
• The default IP address 10.0.0.1 is assigned to the switch without a gateway or boot protocol
configured: Reverse Address Resolution Protocol (RARP) Bootstrap Protocol (BOOTP), and Dynamic Host
Configuration Protocol (DHCP).
If you are adding a switch to a fabric and do not want to accept the default fabric configuration:
1. If the switch is not new from the factory, reset the switch to the factory configuration before adding the
switch to the fabric.
2. If you want to manage the switch through the Ethernet port, you must first configure the IP address.
Plug in the inter-switch links (ISL), but do not connect the devices.
3.
HP StorageWorks SN6000 Fibre Channel Switch Installation and Reference Guide 45