Installation - Salus ERT20RF Instruction Manual

INSTALLATION

Please read the important safety information at the start of this manual before you begin to install the device.
Thermostat
The ERT20RF Thermostat is easily installed using the back plate supplied with the unit – this is used
purely for mounting purposes, as no wiring is needed for the thermostat. The back plate can be mounted
directly to the wall surface.
The ideal position to locate the ERT20RF Thermostat is about 1.5m above floor level. It should be mounted
in a location where the thermostat is accessible, reasonably lit and free from extremes of temperature
and draughts. Do not mount the thermostat on an outside wall, above a radiator or in a location where
it may be subjected to direct sunlight.
To ensure trouble free operation of the Radio Frequency (RF) signal, always ensure that the thermostat
is mounted away from any possible sources of interference (such as radios, TV sets, computers, etc.), and
is not mounted on or in close proximity to large metal objects. Installing the ERT20RF in enclosed areas
such as cellars and basements is not recommended.
1. Mount backplate on wall and ensure correct
orientation.
For replacing the batteries reverse the process in step 3.
When the batteries need replaced the LED below the dial will flash
2. Insert the 2 x AA batteries (supplied). If you
are installing for the first time please put the
thermostat to one side and proceed to page 6.
3. After RF pairing is complete on page 7 then
slide the thermostat onto the backplate ensuring
both sides are engaged. You will feel a positive
click when located properly.
ERT20RF 5