Regulatory Information - Silicon Graphics F180 User Manual

Regulatory Information

Class B
FCC Declaration of Conformance
Trade Name
Product
Model Number
Date of Conformance
Responsible Party
Address
Telephone
This equipment complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant
to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television ch the receiver is
connected.mined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Caution: The user is cautioned that changes or modifications to the equipment not expressly approved by the
party responsible for compliance could void the userís authority to operate the equipment.
Silicon Graphics, Inc.
Monitor
CMN014
May, 2001
Silicon Graphics, Inc.
2011 North Shoreline Boulevard
Mountain View, California
94043-1389
(650) 933-1071