Silicon Graphics F180 User Manual page 10

Installation
Connecting the Display
Figure 2
Power Cord
4.
Connect one end of the AC power cord to the AC adapter
other end to a properly grounded AC outlet that is easily accessible
and close to the display.
5.
Power on the display, then the system.
6.
If you see the NO SIGNAL message, check the signal cable and
connectors.
Note : If you see the INPUT SIGNAL OUT OF RANGE message, check to
A5
3
1
5
4
AC adapter
5
make sure your system is set to one of the factory preset modes (see
page A13), or is set to a resolution and refresh rate within the
specification limits of this display.
2 Dsub
Signal Cable
and the
4