Table of Contents
Advertisement
Booting From Burst Flash Memory
Figure 7-3. Flash Programmer: Programming Dialog Box
Booting From Burst Flash Memory
The
BMODE0—3
the processor's boot loader at reset. On the ADSP-BF548 EZ-KIT Lite,
rotary switch
SW1
position 1 (default) selects the burst flash memory. When
SW1
position 1, every processor reset, including power-on, causes the boot
loader to start processing the contents of flash memory as a boot stream.
7-8
input pins of the processor select the location accessed by
(labelled
DSP BOOT
Getting Started with ADSP-BF548 EZ-KIT Lite
) sets the values of the
pins.
BMODE0—3
is in
SW1
Advertisement
Table of Contents
Need help?
Do you have a question about the EZ-KIT and is the answer not in the manual?
Questions and answers