Table of Contents
Advertisement
2
4
5
6
7
7
Remove the hardware from the arm of a
corner leg fitting in order to insert one of
the legs.
NOTE: Four leg sections are shorter than
the others. These are the center legs. Also,
one leg has two holes near the base. The
see-saw attaches to this leg and needs to be
placed on the opposite side of the slide.
Align the two sets of holes and replace the
hardware through the corner leg fitting and
leg to secure.
Repeat the process for the other side of the
corner leg fitting.
Assemble the center legs and the remaining
outside legs in the same manner as above
and then stand the swing set frame upright.
Remove the hardware for the support bars
from the leg sections. Match up the holes
of the mid-leg and support bar and re-insert
the hardware through both. Repeat the
process for the opposite side and 2 sets of
center legs. It may be necessary to pull
both legs towards each other in order for
the holes to align properly.
NOTE: One support bar has holes for the
slide attachment. The holes should be
positioned toward the front of the swing set.
Part Ref. #: PSHW10
Part Ref. #: PSHW10
Part Ref. #: PSHW10
Part Ref. #: PSHW10
Part Ref. #: PSHW12
2006 Pacific Cycle, Inc.
©
Advertisement
Table of Contents
