Table of Contents
Advertisement
WIRELESS LAN SET Settings
Make the wireless LAN settings in the following order.
1
Video server wired LAN settings (TCP/IP settings)
Make sure that the settings in "Network Video Server
Settings" (p. 9) have been carried out.
2
Wireless LAN device settings (TCP/IP settings)
Refer to the documentation that is provided with the wireless
LAN device for details. The ESS ID, transmission mode and
WEP (encipherment) settings are necessary in order to
complete the video server's wireless LAN settings. Take note
of the settings made.
3
Video server wireless LAN settings (TCP/IP settings)
•
Use the same ESS ID, transmission mode and WEP
(encipherment) settings for the video server's wireless LAN
settings as were made for the wireless LAN device. (p. 46)
Insert the wireless LAN card into the video server (Figure 1)
(1) Insert a commercially-available wireless LAN card into the
video server so that it is facing in the right direction, and
the card will lock in place.
(2) Press the PC card removal button (A) to release the lock,
and then remove the wireless LAN card.
Note:
•
It is recommended that you use one of the following
commercially-available wireless LAN devices that have
been tested by SANYO. In addition, consult your local
dealer for advice on purchasing a wireless LAN card.
Corega : PCCB-11, PCCL-11
ICOM
: SL-11, SL-12
Z-Com : XI-325
•
When a wireless LAN card as been inserted into the
network video server, the video server should be used in
an ambient temperature that does not exceed 40°C.
4
Wireless LAN device settings (TCP/IP settings)
When the settings have been completed, the images from the
video server will be transmitted via the wireless LAN device
and can be viewed on the computer as live images.
English
– 45 –
Computer
Video server
POWER
Computer
Access point
Computer
Video server
POWER
Figure 1
(A)
Computer
Access point
POWER
Video server
Advertisement
Table of Contents
