Table of Contents
Advertisement
Network Video Server (Wired LAN) Settings
2
Menu select buttons
The live image display area and setting area
changes when you click on one of these buttons.
•
[MULTI VIEW] button
This button is used to display images from
cameras that are connected to the VIDEO IN
terminals of the video server in a 4-screen
split screen. This screen is displayed
automatically when a menu screen is
displayed.
Note:
If no live images are being displayed in the
4-screen split screen, the display appears as
follows.
VIDEO LOSS: Appears when a video input
signal is present, but suddenly for some
reason (such as an accident) the signal gets
disconnected.
SANYO: Appears when no video input signal
source is connected. In addition, it appears
when the DISPLAY setting for the camera
title is set to "OFF".
•
[SINGLE VIEW] button
Click this button to operate the devices that
are connected to the video server (such as
dome cameras, time lapse VCRs,
multiplexers or digital video recorders) singly
or as a group.
•
[VIEW FRAME] button
If the live images are displayed in a 4-screen
format, the images at either side may not be
visible. In such cases, click this button to
display live images in a single screen. The
image area will be displayed in a fixed image
size (720 x 480).
•
[NETWORK] button
Used when making network settings.
•
[WIRELESS LAN] button
Used when making wireless LAN settings.
•
[PPP] button
Used when setting up an Internet connection
using a modem.
Archive software (sold separately) is required
when using these settings.
•
[DISPLAY] button
Used when making settings such as camera
title and image quality (aperture and contrast)
for a camera.
•
[ALARM] button
Used when making settings for alarm
recording and motion sensors.
English
•
[CLOCK] button
Used when setting the video server's clock.
•
[RS-232C] button
Used when setting the communication speed
when the video server is connected directly
to the computer.
•
[SSP] button
Use this button to carry out SSP control.
•
[LANGUAGE] button
Click this button if you would like to change
the language. The language selection screen
will be displayed.
•
[STATUS] button
Used when checking firmware versions and
information relating to the video server.
3
Network disconnect button
Click this button to shut down operation of the
network video server. The following message will
be displayed when this button is clicked. To
reconnect the video server, click the
button in the title bar.
4
[Get JPEG2000 PLUG-IN] button
If you need to install the JPEG2000 plug-in
software, click this button to point the browser to
a website page for downloading the software.
Select "JPEG2000 Plug-in Software" and then
start the download. You will need an Internet
connection in order to download the software.
– 15 –
(Refresh)
Advertisement
Table of Contents
