Wired Lan Settings - Sanyo VSP-SV2000P Instruction Manual

Network Video Server (Wired LAN) Settings

2 Wired LAN Settings

Once the plug-in software has been installed, use the computer's web browser to access the video
server.
Note: The network video server handles large volumes of image data that has been compressed into
JPEG2000 format. In order to provide smooth access to the video server, you should close any
other applications that you do not need to have open.
1
Use an Ethernet cable to connect the
network video server and the computer.
Refer to "Basic connections" in the
"Connections" section.
2
Click on the Network Connections icon in
the computer's Control panel, and then
make the Internet protocol settings (IP
address and subnet mask) for the
computer.
•
IP address setting:
The video server's IP address is set to
"192.168.0.2", so type in a spare number
that is 3 or higher for the IP address.
Example: "192.168.0.101"
•
Subnet mask setting:
Type in "255.255.255.0".
3
Start the web browser on the computer,
type "http://192.168.0.2/" into the location
bar and then press the [Enter] key.
The password entry window will be displayed.
English
4
Type in the username (ID3) and the
password (3333), and then click the [OK]
button.
The language selection window will be
displayed.
Note: The username and password settings in
this screen are initially set to the
Administrator level settings (ID: "ID3";
password: "3333") so that all required
settings can be made. There are separate
passwords for each of the three access
levels (Administrator, Operator and User),
and the passwords can be changed.
Refer to "Access Level Settings" for
further details.
Language selection window
The initial screen will be displayed.
– 13 –