SALSA
Parts in the battery box, (Fig.13.22):
•
Sliding support tray for 2 x 12V batteries.
•
2 x battery looms with fuse and ring terminals.
•
Battery link harness with red and grey connectors.
Accessing the Batteries
•
Undo the TWO securing knobs on the rear cover,
(Fig.13.17).
•
The TWO battery connector plugs are visible.
•
Disconnect the RED plug.
•
Disconnect the GREY plug, (Fig.13.18).
•
Grab the rear chassis between the stabiliser wheels
& pull backwards. The battery tray will slide out,
(Fig.13.19).
•
Handle the batteries using the straps provided.
•
Always use correct lifting techniques as batteries are
heavy.
The two battery looms are identical. One is required to be
connected to each battery:
•
To disconnect the batteries, lift up the insulator sleeve
& use 11.0mm spanner to undo the bolt. Always fit the
insulator sleeve when reinstalling, (Fig.13.20).
•
The red wire containing the 150A fuse connects to the
battery Positive (+) terminal, (Fig.13.21).
•
The other black wire connects to the battery Negative
(-) terminal, (Fig.13.20)
•
The battery terminals must be covered after connection
with the caps provided on the cable.
•
Both batteries are fitted to the battery tray with the
terminals rear-most, so that the grey connectors can
be mated with the battery link harness.
•
Ensure the link harness is secured in the slots provided
in the tray.
•
If you are in any doubt, please contact your Sunrise
Medical authorised dealer.
Fig.13.17
Rev.5.0
Fig.13.18
Fig.13.19
Fig.13.20
Fig.13.21
Fig.13.22
71
SALSA/SALSA M