Hardware Installation - Linkcom Link View CBL2MP User Manual

B. Hardware Installation
1. Connector Instruction
The Cable and connector is as below. Connect power adaptor first,
then connect the IP Camera to PC or network, and set up the network
configurations according to the network environment. About I/O setting,
please refer to chapter VII in User Manual: "I/OConfiguration" for detail.
2. You can use 3-Axis bracket to adjust the angle of camera. Please lock the
screws tightly to fix the angle after adjusting.
3. This IP camera is equipped with an external vari-focal lens controller. Please
adjust "ZOOM" and then "FOCUS" as following picture until the image gets
clear.
8