Viii.factory Default - Linkcom Link View CBL2MP User Manual

VIII.Factory Default

If you forget your password, please follow the steps to revert back to default value.
• Remove the power and ethernet cable.
• Take a electronic wire, plug one side of the wire into "Default" and the other
side into "GND" on the terminal block as the picture below.
• Connect power to the camera again. It takes around 30 seconds to boot the
camera.
• Remove the wire and plug in the ethernet cable after the camera finishes
booting.
• Re-login the camera using the default IP (http://192.168.1.200), and user name
(admin), password (admin).
61