This is the Username needed access the router's web management interface. When you attempt to connect to the device through a web browser you will be prompted to

enter this Username. The default Username for the router is "admin".

Password

This is the Password you will be prompted to enter when you access the router's web management interface. The default Password is "admin".

LAN IP Addresses for the Router

This is the IP address you will enter into the Address field of your web browser to access the router's configuration Graphical User Interface (GUI) using a web browser. The

default IP address is 192.168.1.1. This may be changed to suit any IP address scheme the user desires. This address will be the base IP address used for DHCP service on

the LAN when DHCP is enabled.

LAN Subnet Mask for the Router

This is the subnet mask used by the router, and will be used throughout your LAN. The default subnet mask is 255.255.255.0. This can be changed later.

Information needed about your LAN or computer

Ethernet NIC

If your computer has an Ethernet NIC, you can connect the router to this Ethernet port using an Ethernet cable. You can also use the Ethernet ports on the router to connect

to other computer or Ethernet devices.

DHCP Client status

Your ADSL router is configured, by default, to be a DHCP server. This means that it can assign an IP address, subnet mask, and a default gateway address to computers on

your LAN. The default range of IP addresses the router will assign are from 192.168.1.2 to 192.168.1.254. Your computer (or computers) needs to be configured to obtain an

IP address automatically (that is, they need to be configured as DHCP clients.)

Once you have the above information, you are ready to setup and configure your ADSL router.

Basic Installation

Page 11

Table of Contents