Table of Contents
Advertisement
Check your IP address
After you installed your new network or wireless adapter, by default, the TCP/IP
settings should be set to obtain an IP address automatically from a DHCP server. By
default the DHCP server option on your router is enabled.
To verify your IP address, please follow the steps below:
•
Click on the Windows Start button and open the Run application.
•
In the Open box type cmd and click OK.
•
At the command prompt, type in the command ipconfig and press Enter. This
will display the IP address, Subnet Mask, and the Default Gateway of your
adapter. If the address is 0.0.0.0, it means that your network adapter did not
receive an IP address from the DHCP server. Check your adapter installation,
security settings, and the settings on your router. Some firewall software
programs may block a DHCP request on newly installed adapters.
Knowledge Base
Dual Band AC1750 Gigabit ADSL2+ Modem Router User Manual
Knowledge Base
Networking Basics
Page 178
Hide quick links:
Advertisement
Table of Contents
