Customizing Features/Options (M20/27/30); Recharge Tonight - Morton System Saver M20 Installation And Operation Manual

Customizing Features / Options
Recharge Now
At times of greater than normal water use, such as
when you have guests, you could run out of condi-
tioned water before the next scheduled recharge. If
this happens, you may want to initiate an immediate
regeneration, as follows:
1. Press and hold the RECHARGE button until the
words "RECHARGE NOW" flash in the display.
RECHARGE NOW initiated
During the recharge cycle, the screen will flash
"RECHARGE NOW". When the recharge cycle is
complete, full softened water capacity will be
restored.
NOTE: Avoid using hot water while the softener is
regenerating, because the water heater will
refill with bypass hard water.

Recharge Tonight

If you do not want to start an immediate recharge, but
would like to schedule an extra recharge at the next
preset recharge time, do the following:
1. Press and release (do not hold) the RECHARGE
button.
RECHARGE TONIGHT initiated
The words "RECHARGE TONIGHT" flash in the dis-
play, and the softener will recharge at the next
recharge time. The words "RECHARGE NOW" will
flash during the regeneration. When completed, full
water conditioning capacity is restored.
(Models M20, M27 & M30)
FIG. 23
FIG. 24
Morton System Saver Installation & Operation Manual
® ®
Adjustable Backwash
If your incoming water supply has higher sediments
or clear water iron, a longer Backwash and/or Fast
Rinse time may help in keeping the unit cleaner.
To change the length of the Backwash:
1. Press and hold the SELECT button until the screen
in Figure 25 is displayed.
2. Press the SELECT button twice, so that "bA TIME"
appears in the display (See Figure 26).
q
3. Press the UP or DOWN buttons to set the
length of Backwash in minutes.
4. When the desired Backwash time appears in the
display, press the SELECT button twice to return to
the normal run (time of day) screen.
Adjustable Fast Rinse
To change the length of the Fast Rinse:
1. Press and hold the SELECT button until the screen
in Figure 25 is displayed.
2. Press the SELECT button three times, so that "Fr
TIME" appears in the display (See Figure 27).
q
3. Press the UP or DOWN buttons to set the
length of Fast Rinse in minutes.
4. When the desired Fast Rinse time appears in the
display, press the SELECT button once to return to
the normal run (time of day) screen.
FIG. 25
FIG. 26
FIG. 27
15