Controller Features - Morton M45C Installation And Operation Manual

Optional Settings:
Salt Efficiency
=
Clean Feature
=
Clean Feature Minutes
=
Maximum Days Between
=
Regenerations
97% Feature
=
12 / 24 Hour Clock
=
Backwash & Fast Rinse Times
=
1. To set any of these options, press and hold the
SELECT button for 3 seconds until "000" shows in
the display.
Then press (do not hold) SELECT again to display
one of the "Salt Efficiency" screens shown below.
Efficiency Icon
Salt Efficiency:
When this feature is ON, the
water softener will operate at salt efficiencies of
4000 grains of hardness per pound of salt or high-
er. The softener may recharge more often using
smaller salt dosage and less water. This softener
is shipped with the efficiency feature set OFF. Use
q
the UP or DOWN buttons to change between
OFF and ON. An efficiency icon will be displayed
when this feature is ON.
Displayed when efficiency
is set to "ON"

Controller Features

FIG. 43
FIG. 44
FIG. 45
Morton Water Softener Installation & Operation Manual
®
California Efficiency Requirement
Your Morton Water Softener has a "High
®
Efficiency" feature with an ON or OFF setting.
This softener setting is shipped in the OFF posi-
tion, which utilizes the maximum rated capacity
while most often achieving maximum salt effi-
ciencies. When installing this unit in the State of
California, you MUST turn this setting to the ON
position, which may initiate more frequent
recharges. However it will operate at 4000
grains per pound of salt or higher.
If you wish to turn the Salt Efficiency feature ON
( icon will show in the display), follow the
instructions on this page.
2. Press SELECT again to display the "Set Clean"
screen.
Clean:
This feature is beneficial on water sup-
plies containing iron and/or high amounts of sedi-
ments (sand, silt, dirt, etc.). When set to ON, a
backwash and fast rinse cycle will occur first, pre-
ceding the normal regeneration sequence. This
provides extra cleaning of the resin bed before it is
regenerated with the salt brine. To conserve water,
if your water supply does not contain iron or sedi-
ments, be sure this feature is set to OFF. The
default is OFF. Use the
to change between OFF and ON.
3. Press SELECT again to display the "Set Clean
Time" screen.
Clean Feature Minutes:
Clean Feature ON, the length of the extra back-
wash cycle auto matically is set to 7 minutes.
FIG. 46
q
UP or DOWN buttons
FIG. 47
If you have set the
continued on next page
19