Table of Contents
Advertisement
Remote Control Programming & Operation
Another group of keys may only be pro-
grammed with one remote code. The
code contained in these keys remains the
same regardless of the source selection.
WARNING: These keys transmit codes
that are vital to the operation of the
product. It is not recommended that they
be programmed with alternative codes,
as it may then be impossible to operate
certain functions of the receiver.
THX
Aux
Cursor Up
⁄
Pro Logic
Delay
Cursor Down
¤
Dolby 3 Stereo
Memo
Cursor Right ›
Movie
Screen Display
Cursor Left ‹
Matrix
Panel Display
Select
Hall
Speaker
Main Volume Up
⁄
Stereo
Test Noise
Main Volume Down
¤
Mono
Adjust
Mute
6Ch Direct
To program the remote, follow these steps.
Note that it is not necessary to program
all keys, only those that are required to
operate the subject device. Keys not pro-
grammed will retain the codes prepro-
grammed at the factory.
18
1. Slide
switch at the
Use/Learn a
top left corner of the remote to the right
so that it is next to
.
Learn
2. If one of the multi-function buttons is
being programmed press the source but-
ton (i.e.
,
, etc.) you wish to
CD
VCR
have this function associated with. If you
are programming a single function key,
proceed to the next step.
3. Press the button on the remote that is
to be programmed. Note that the
LED will illuminate.
Learning y
4. Place the remote head to head with the
remote control whose function is being
learned. The two remotes should be no
more than 8 inches apart.
5. Press and hold the button on the
remote corresponding to the function to
be memorized until the
Learning
starts to blink. When the LED goes out,
release the button on the transmitting
remote. The function code has been suc-
cessfully captured by the remote.
NOTE: If both LEDs flash during a pro-
gramming operation, it indicates that
the remote's memory is full or that the
remote codes from the transmitting
remote are not compatible with the unit's
signal format.
6. Continue to program any additional
remote commands required using steps
2 through 5. When you have finished
programming the remote, slide the
switch to the left so that it
Use/Learn
is in the
position.
Use
Clearing the Remote Memory
In normal operation, codes for a new
device may be programmed "over" the
codes that have been previously pro-
grammed into the remote. It is also pos-
sible to clear the memory for individual
keys, or for the entire remote. When a
memory position is cleared, the remote
will return to the original factory preset
command.
To clear the memory for a specific indi-
vidual key location, put the
switch in the
Learn
Main Power Off b
button to be cleared at the same time.
Both the
Sending
cators will light momentarily. When the
lights go out, the memory has been
cleared of the user programmed code
and returned to the factory preset. Return
the
Use/Learn a
LED
position when you are finished.
To clear the remote's entire memory
and return all keys to their factory preset
commands first put the
switch in the
Learn
the
Main Power On
confirm that the
y
has illuminated. While continuing
to press the
Power On
hold the
Power Off b
indicator goes off for about 3 sec-
Learn
onds. It will then blink twice. Then
release the two buttons. This indicates
that the memory has been cleared of any
user programmed commands and that
the original commands have been
restored. Slide the
back to the
Use a
the remote to normal operation.
Use/Learn
position. Press the
button and the
and
indi-
Learning
switch to the
Use
Use/Learn a
position. Then press
button
b
and
indicator
Learning
button, press and
button until the
switch
Use/Learn
position to return
Hide quick links:
Advertisement
Table of Contents
