HP ProLiant BL30p Maintenance And Service Manual page 58

Connectors, LEDs, and Switches
Accessing the Redundant ROM
If the system ROM is corrupted, you can set the system to use the backup version or
redundant ROM.
To use the redundant ROM:
1. Power down the server blade:
— Press the Power On/Standby button on the front of the server blade.
— Use the virtual power button feature in the iLO remote console.
2. Disconnect the server blade from all power sources:
— Remove the server blade from the enclosure and set it on a flat, level surface.
— Disconnect the server blade from the diagnostic station.
3. Change positions 1, 5, and 6 of SW1 to on.
4. Connect the server blade to system power:
— Install the server blade in the enclosure.
— Connect the server blade to the diagnostic station.
5. Power up the server blade:
— Press the Power On/Standby button on the front of the server blade.
— Use the virtual power button feature in the iLO remote console.
6. As soon as the server blade powers up, it emits two beeps.
7. Repeat steps 1 through 3.
8. Change positions 1, 5, and 6 of SW1 to off.
9. Repeat steps 5 through 7.
If both the current and backup versions of the ROM are corrupt, you must return the system
board for a service replacement. For spare part numbers, refer to Chapter 1, "Illustrated Parts
Catalog."
4-14
HP ProLiant BL30p Server Blade Maintenance and Service Guide