HP ProLiant BL30p Maintenance And Service Manual page 21

Removal and Replacement Procedures
Figure 2-8: Replacing the center plate
NOTE: Be sure that the jumper on the drive is set to Cable Select (CS) so that the drive device ID is
determined by the cable.
IMPORTANT: Be sure the center plate is oriented as in the following figure. The pins must be pointed
down when being installed into the main cage.
Figure 2-9: Replacing cover plate on the drive cage assembly
IMPORTANT: Be sure to connect the hard drive in the primary (bottom) bay to the primary (bottom)
connector on the hard drive cable and connect the hard drive in the secondary (top) bay to the
secondary (top) connector on the hard drive cable.
HP ProLiant BL30p Server Blade Maintenance and Service Guide 2-9