Nic Riser Board - HP ProLiant BL30p Maintenance And Service Manual

NIC Riser Board

To remove the NIC riser board:
1. Power down the server blade and remove it from the server blade enclosure. Refer to the
"Server Blad e Preparation" section in this chapter.
2. Remove the FC adapter. Refer to "Dual Port Fibre Channel Adapter" in this chapter.
3. Loosen the thumbscrews (1).
4. Remove the NIC riser board (2).
Figure 2-21: Removing the NIC riser board
Reverse steps 1 through 4 to replace the NIC riser board.
HP ProLiant BL30p Server Blade Maintenance and Service Guide
Removal and Replacement Procedures
2-19