Using The Accessories - AEG BP5014301 User Manual

12 www.aeg.com
time you set is longer than 60 mi-
nutes, the symbol
the display. The appliance then cal-
culates the time in hours and mi-
nutes.
3. The Minute Minder starts automati-
cally after five seconds.
After 90% of the set time, an
acoustic signal sounds.
4. When the set time ends, the acous-
tic signal sounds for two minutes.
00:00 and
Press a button to stop the signal.
If you set the Minute Minder
when the Duration or End func-
tion operates, the symbol
comes on in the display.

7. USING THE ACCESSORIES

WARNING!
Refer to the Safety chapters.
7.1 Core temperature sensor
The core temperature sensor measures
the core temperature of the meat. When
the meat is at the set temperature, the
appliance deactivates.
There are two temperatures to be set:
• The oven temperature. Refer to the ta-
ble for roasting.
• The core temperature. Refer to the ta-
ble for the core temperature sensor.
Only use the core temperature
sensor supplied with the appli-
ance, or genuine replacement
parts.
1. Set the oven function and the oven
temperature.
2. Put the point of the core tempera-
ture sensor (with the symbol
the handle) into the centre of the
meat.
comes on in
flash in the display.
on
6.3 Count Up Timer
Use the Count Up Timer to monitor how
long the oven operates. It is on immedi-
ately when the oven starts to heat.
To reset the Count Up Timer, press and
hold + and -. The timer starts to count
up again.
You cannot use the Count Up
Timer when the Duration
End function operates.
3. Put the plug of the core temperature
sensor into the socket on the front of
the appliance. The display shows the
symbol of the core temperature sen-
sor and the default core tempera-
ture. When you use the core temper-
ature sensor for the first time, the
default core temperature is 60 °C.
4.
While flashes, you can use the
knob for the temperature to change
the default core temperature.
5.
Press to save the new core tem-
perature , or wait 10 seconds for the
setting to be saved automatically.
The new default core temperature is
or