Original - Hunter Dual Function Bowl Light Kit Owner's Manual And Installation Manual

4 • Installing the Light Kit on the Hunter Original
1 . Uninstall the two screws from the switch housing plate .
NOTE: Save the switch housing cap should you choose to remove the light
fixture in the future .
2 . Remove the wire connectors from the two wires in the switch housing
labeled "Connect Light Here" or "For Light Use . " One wire is white and the
other wire is black wire with a white stripe . Thread the two wires through
the hole in the center of the light fixture .
3 . Unscrew the nut and washer from the threaded rod at the top of the light
kit to remove the mounting plate and replace it with the smaller switch
housing cover included with the light fixture .
4 . To connect the wires, hold the bare metal leads together and place a wire
connector over them, then twist the wire connector clockwise until tight .
Connect the black wire with a white stripe from the switch housing to
the black wire from the light kit . Connect the white wire from the switch
housing to the white wire from the light kit . Secure all wire connections
using wire connectors .
CAUTION: Be sure no bare metal wires or wire strands are visible after
making the connections .
5 . Attach the light fixture to the switch housing with the two screws,
included with the light fixture, aligning the holes in the fixture, switch
housing cover, and switch housing .
6 . Securely tighten the two screws .
7 . Go to the instructions for Installing the
Bulbs, Chains, and Globe .
WARNING: Improper installation
could cause the light fixture to
fall, or result in electrical shock or
personal injury .
10
43550-01 • 06/10/10 • Hunter Fan Company
Hunter Original
Screw
Step 1
Switch
Housng
Cover
(included
with the
light
fixture)
Light
Fixture
Step 5
Switch
Housing
Plate
Step 4