Option 1: Connect The Handset Lifter To A Corded Phone - AT&T TL7612 User Manual

Getting started
Headset base and handset lifter installation

Option 1: Connect the handset lifter to a corded phone

1. Unplug the curly handset cord from the telephone and plug
it into the
headset base.
2. Plug one end of the telephone line cord (provided with the
headset base) into the base handset jack on the telephone
where the curly handset cord was originally plugged in.
3. Plug the other end of the line cord into the BASE JACK
(orange dot) on the headset base.
4. Plug the lifter control cable into the jack of the base adapter.
5. Plug the other end of the base adapter into the LIFTER jack
(blue dot) on the headset base.
Adjust the corded handset audio (see page 18) before you install the
handset lifter to your telephone. See page 19 to attach the handset
lifter. Make sure the headset base mode is set to LIFTER MODE.
Plug the small end of the
headset base power adapter
to the POWER jack (green dot)
on the headset base.
Plug the large end of the
headset base power adapter
into a power outlet not
controlled by a wall switch.
Telephone
wall jack
A DSL filter (not included)
is required if you have DSL
high-speed Internet service.
CURLY CORD jack (light blue dot) on the
Telephone
line cord
3
5
1
4
17
2