OPERATING HAZARDS GENERAL SAFETY RULES ■ Avoid contact with the rotating spindle and inserted ■ For multiple hazards, read and understand the safety tool to prevent cutting of hands and other body parts. instructions before installing, operating, repairing, ■ Use of the tool can expose the operator's hands to maintaining, changing accessories on, or working hazards, including cuts and abrasions and heat.
■ Avoid direct contact with the inserted tool during and should be correctly used and maintained in accordance after use as it can be hot or sharp. with the manufacturer's instructions. ■ The maximum operating speed of the inserted tool ■...
increase in vibration levels. ■ Select, maintain and replace the consumable/inserted Lubricate with air tool oil daily. tool as recommended in the instruction handbook, to prevent an unnecessary increase in vibration levels. ■ Support the weight of the tool in a stand, tensioner or SPECIFICATIONS balancer if possible.
3. Danger of injury and property damage caused by placing a sheet of paper next to the exhaust ports and holding the throttle open for approximately 30 seconds. flying objects. The lubricator is properly set when a light stain of oil collects on the paper.
possible failure. ■ Pour air tool lubricating oil into air inlet as per instructions. ■ Maintenance shall be performed weekly. ■ Operate tool in short bursts quickly reversing rotation ■ Drain the air tank daily. Water in the air line will back and forth where applicable.
PARTS LIST Description Description Description Description Air inlet Screw cap Bolt 2 x 6 Retainer ring Muffle cover Trigger Cylinder Front plate Valve stem Roll pin 3 x 14 Rotor Collet seat O-ring 4.8 x 1.6 Spring Rotor blade Collet O-ring 5.6 x 2 Trigger lock pin Washer...
Page 10
Techtronic Industries (Australia) Pty. Ltd. Level 1, 660 Doncaster Road Doncaster, VIC 3108, Australia Techtronic Industries New Zealand Ltd. 18-26 Amelia Earhart Avenue Mangere, Auckland 2022, New Zealand...