Advertisement

ORIGINAL INSTRUCTIONS
Angle Grinder
RAG80125

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the RAG80125 and is the answer not in the manual?

Questions and answers

Summary of Contents for Ryobi RAG80125

  • Page 1 ORIGINAL INSTRUCTIONS Angle Grinder RAG80125...
  • Page 2 Important! It is essential that you read the instructions in this manual before assembling, operating, and maintaining the product. Subject to technical modification.
  • Page 3: Intended Use

    Safety, performance, and dependability have been given (RCD) protected supply. Use of an RCD reduces top priority in the design of your angle grinder. the risk of electric shock. PERSONAL SAFETY INTENDED USE a) Stay alert, watch what you are doing and The angle grinder is intended to be used only by adults who use common sense when operating a power have read and understood the instructions and warnings...
  • Page 4: Angle Grinder Safety Warnings

    f) Keep cutting tools sharp and clean. Properly shield, safety goggles or safety glasses. maintained cutting tools with sharp cutting edges As appropriate, wear dust mask, hearing are less likely to bind and are easier to control. protectors, gloves workshop apron capable stopping...
  • Page 5: Additional Safety Instructions For Grinding And Cutting-Off Operations

    pinching. Abrasive wheels may also break under these ADDITIONAL SAFETY WARNINGS SPECIFIC FOR conditions. ABRASIVE CUTTING-OFF OPERATIONS Kickback is the result of power tool misuse and/or incorrect a) Do not “jam” the cut-off wheel or apply operating procedures or conditions and can be avoided by excessive pressure.
  • Page 6: Residual Risks

    Keep hands away from the grinding good condition. area at all times. Clamp the workpiece whenever ■ It is recommended that you take the product to a Ryobi possible. authorised service centre for a thorough cleaning and ■ Injury caused by noise lubrication at least once a year.
  • Page 7: Environmental Protection

    WARNING Waste electrical products should not be disposed of with household waste. Please Do not use compressed air to blow dust from the product. recycle where facilities exist. Check with your This practice is dangerous and can cause dirt and grit to local authority or retailer for recycling advice.
  • Page 20: Product Specifications

    PRODUCT SPECIFICATIONS Angle Grinder Model RAG80125 Grinding wheel: Diameter 125 mm (5 in.) Thickness 6 mm Rated voltage 220 - 240 V 50 Hz Rated capacity 125 mm Input 800 W Spindle thread M 14 Rated speed 12000 min Net weight...
  • Page 22 Imported by: Techtronic Industries (Australia) Pty. Ltd. 31 Gilby Road, Mount Waverley VIC 3149, Australia Techtronic Industries New Zealand Ltd. 2 Landing Drive, Mangere, Auckland, New Zealand 2022 20160919v1...

Table of Contents