Advertisement
4. Insert the other steering tube into the upper sec-
tion.
5. Insert the steering tube into the bracket on the
right-hand side.
6. Turn back the entire steering into the upright po-
sition.
7. Fit the screws. Tighten securely.
8. Secure the electrical cable into the cable holder.
9. Fix the electrical cable using a cable tie.
COLLAPSIBLE HANDLEBAR (fig. 2)
1 . Insert the steering shaft into the handlebar arch.
2. Fit the screws. Tighten securely.
3. Press the plugs into the steering sockets. Ensure
that the plugs are inserted inthe correct end.
4. Press the steering sockets into the holes in the
chassis.
5. Fit the screws. Tighten securely.
6. Attach the handlebar to the steering sockets us-
ing screws, washers and locking knobs. The han-
dlebar can be tilted forward by loosening the
locking knobs slightly. The mower will then take
up less space during transportation.
7. Secure the electrical cable into the cable holder.
8. Fix the electrical cable using a cable tie.
GRASS COLLECTOR (fig. 4)
Snap-together the grass collector's upper and lower
parts.
Open the cover on the machine and hook the grass
collector onto the chassis.
NOTE! The lawn mower can be used without the
grass collector. The grass will then collect in a bead
behind the machine.
USING THE MOWER
CONNECTION (fig. 5)
Only use an extension cable that is approved for
outdoor use with a maximum length of 50 m. It
should not be lighter than type 245 IEC 53
(H05RR-F) or 227 IEC 53 (H05VV-F). If you are
unsure of anything, please contact your dealer.
ENGLISH
To increase safety the lawn mower should be con-
nected to an earth-fault breaker.
Support the extension cable in the cable support on
the steering.
START/STOP (fig. 6)
Start the mower on flat, solid ground. Do not start
in long grass. Press on the steering so that the front
wheels lift slightly from the ground to reduce grass
resistance.
Starting the motor:
1. Press the button
2. Pull the handle towards the steering.
Stopping the motor: Release the handle.
CUTTING (fig. 7)
Always cut away from the cable.
Empty the grass collector in good time so that the
grass deflector does not get blocked and reduce
grass collection capacity.
To avoid overloading the motor, do not push the
mower too quickly in long grass.
CHANGING BLADES (fig. 8)
Always pull out the plug before carrying out main-
tenance, cleaning or other actions on the machine.
Wear protective gloves. Loosen the blade bolts us-
ing a 26 mm spanner. Fit a new blade. Tightening
torque 15 Nm.
Always use genuine spare parts.
CLEANING AND STORAGE (fig. 9)
Always wipe or brush off the mower after use.
The cold air intake around the motor casing should
always be kept free from grass and dirt so that the
motor does not overheat.
The underside of the chassis can be scraped clean.
Never rinse with water.
The mower should be stored in the dry.
MAINTENANCE
GB
Advertisement
