How To Wall Mount - Tannoy arena Highline 500 LCR Owner's Manual

ARENA HIGHlINE 500 lCR (for centre channel position)
How to wall mount
WARNING: It is your responsibility to ensure that the bracket to wall fixing
screws or bolts and the walls themselves are strong enough to support the
weight of the speaker - refer to the speaker weight specifications supplied
in this manual. Particular care is needed when fixing to hollow or cavity
walls - ''stud'' walls. Use only professionally recommended fixing devices
which will spread the load of the brackets and fixing screws over an area of
the wall surface when mounting to cavity walls. Pay particular attention
to the possibility of electrical cables and gas or water pipes which may be
present in the wall cavity or buried in the wall surface. Use a special cable
or metal proximity locator to locate these obstacles if in any doubt.
Before wall mounting the centre wall bracket, ensure sufficient clearance
to hook the speaker onto the bracket (approx half the speaker length to the
left or right of the bracket).
Use a spirit level to ensure the bracket is fitted level.
Mount the bracket on the wall with a suitable fixing (not supplied - see
warning note).
Using the 8mm screws and washers provided attach the two small brackets
to the fixing points. Ensure that the bracket with pre fitted cap has the cap
facing outwards, on the side you have left clearance for hooking onto the wall.
Thread the speaker wire through the spare cap.
Important note: It is essential that the speakers are wired correctly at this
stage. The (-) wire should have a solid black line or similar marked along it.
Screw the (+) wire into the red terminal and screw (-) wire into black terminal.
3
13