Setup And Assembly; Setup And Assembly For The Kem - Nortel NN10300-011 User Manual

.

Setup and assembly

This section describes the setup and assembly for the Nortel IP Phone
Key Expansion Module (KEM) and the Nortel IP Phone Graphical
Expansion Module (GEM).

Setup and assembly for the KEM

Nortel IP Phone Key Expansion Module (KEM) mounts on the right side of
the IP Phone as shown in
(page
to secure the KEM to the IP Phone.
Figure 6
KEM attached to an IP Phone 2002
KEM attaches to the IP Phone or another KEM through the accessory
expansion module (AEM) interface.
Extending from the left side of the KEM is a 10-pin female header on a
ribbon cable that is connected to inside of the module. Use this ribbon
cable to:
Copyright © 2008 Nortel Networks
.
Figure 6 "KEM attached to an IP Phone 2002"
17). A desk-mount bracket and a structural baseplates are provided,
Carrier VoIP
Nortel IP Phone Expansion Module User Guide (CICM)
NN10300-011 09.01 Standard
4 July 2008
17