Table of Contents
Advertisement
34
Nickel (Cast Iron) Doors Only
Use a socket-head wrench with 5/16" socket to pre-thread the holes 6 revolutions. If you pre-thread
move revolutions, it may bottom out and break the head off the screw. Remove and retain the screws.
See the photos below.
4. Place the door retainer into the door shell as shown below.
© Travis Industries
Index
Door Retainer
Door Shell
The indent on the door retainer slides into
the clip on the door shell (on both sides).
100-01161
4040909
Advertisement
Table of Contents
