Part Names And Functions - Fujitsu Plasmavision PDS4208W-B User Manual

PART NAMES AND FUNCTIONS (Continued)
Remote Control
1
VIDEO
3
MENU
VOL
8
ENTER
SHIFT
1
2
3
4
Strap hole
PUTTING BATTERIES IN THE REMOTE CONTROL
1 To remove the cover, slide it
outwards while pressing it down.
Note
The remote control will not function properly if the batteries are dead. Be sure to replace them as needed.
Make sure that you use replace the batteries with new ones; also, be sure to use replacement batteries of the same type as the original ones.
12
1 Power ON button [POWER ON]
Turns the power ON.
2
2 Power OFF button [POWER OFF]
5
4
Turns the power OFF.
3 RGB input mode selector button [RGB]
6
Switches between RGB input modes.
7
4 Video input mode selector button [VIDEO]
Switches between video input modes.
9
5 Wide screen selector button [WIDE]
Switches the screen over to a desired wide screen.
6 Menu button [MENU]
= Use this button to display a desired menu for adjusting the image and sound.
7 Volume adjustment buttons [VOL +/-]
Unused.
8 Adjustment buttons [
Use these buttons to scroll through options in a menu and change values.
9 Enter button [ENTER]
Press this button to finalize the selection of a desired menu or option within a menu.
0 Display selector buttons [SHIFT 1–4]
When you use two or more displays, you can use these buttons to control up to four displays
by assigning a unique number to each of the displays.
2 Put two AA batteries in the remote
control. Make sure that the batteries
are properly oriented.
/ / / ]
3 Close the cover until it snaps into
➝ (See P. 16.)
➝ (See P. 16.)
➝ (See P. 17.)
➝ (See P. 17.)
➝ (See P. 18–19.)
➝ (See P. 20–35.)
➝ (See P. 20–35.)
➝ (See P. 20–35.)
➝ (See P. 28–29.)
place.