Table of Contents
Advertisement
Digital Video Network Surveillance System
Switch the device power on, wait without any operations until preview screen
appears, and then you can use IR remote control to manage DVR on condition that the
device ID is default "255", which can be changed in "Display" menu.
If the default device ID has been changed, please press [Power] & [DEV] key of
IR remote control, input the present device ID and then press [ENTER] key. Then you
can use IR remote control to operate this DVR.
Stop using IR controller
When IR controller status is on, press [DEV]key again, the "STATUS" lamp will
be turned off. The IR controller can not control this DVR.
Switch the DVR off
Turn off the power switch directly.
When IR controller can not work normally
Check batteries poles.
Check the remaining charge in the batteries.
Check IR controller sensor is mask.
Please change another IR controller to try again. It the problem is still existed,
please contact administrator.
Unisight Digital Technologies, Inc.
10
Advertisement
Table of Contents
