Netgear Gateway Configuration For Remote Client Access; Configuration Of The Gateway Via The Gui - Telstra DEVG2020 User Manual

4. NETGEAR GATEWAY CONFIGURATION FOR REMOTE CLIENT
ACCESS
This section describes the connection configuration details for remote client use to access the Gateway.

4.1. CONFIGURATION OF THE GATEWAY VIA THE GUI

This section outlines how to configure VPN access from the Netgear gateway GUI after the initial Wizard
installation
Under the 'ADVANCED' tab, click on the 'VPN' menu and then click on the 'Manage VPN' link.
1.
Configurig VPN Connection
Under the 'Remote Client to GW VPN Configuration' heading, Click the 'Edit' button to activate
2.
the Pre-Shared Key (PSK) textbox.
3. Enter a Pre-Shared that will be used for the Phase 1 IKEv1 negotiation and then click the
adjacent 'Save' button. (This is an alpha-numeric string with a maximum length of 32 characters)
In the 'VPN remote Virtual IP' and 'Mask' fields, enter the IP address and Subnet Mask. This will
4.
determine the pool of IP addresses to assign to the Clients connecting through VPN. (NOTE: this
IP address range entered here must be separate to the LAN IP address setup for this DEVG2020
device.)
Click the 'Save' button.
5.
Adding Remote VPN Users
Under the 'VPN Users' heading, Click on the 'Add' button.
6.
7. Enter the Username and Password for the client to connect with into the corresponding text
boxes
Click on the 'Save' button to confirm the details.
8.
9. Repeat steps 7-9 for any additional client users.
Enabling VPN Status
Under the 'VPN Status' heading, click on the 'Enable' radio button.
10.
Click on the 'Apply' button at the top of the frame.
11.
VPN CONFIGURATION GUIDE PREMIUM BUSINESS GATEWAY - DEVG2020
VERSION 2.03
12